Well, my attempts to create a mascot to promote better use of cutlery around the world went terribly wrong and I ended up with this
 however im confident alternative uses could be found.
This is a relatively complex model cast in 11 pieces across 4 moulds, allowing a certain degree of pose-ability:
Torso
2 x blade arms
Rear leg A + toe
Rear leg B + toe
Front leg A +toe
Front leg B + toe
The torso was cast in a 3 part mould and as a result of this it can suffer from serious mould lines on the underside, however there are not really visible once the legs are stuck on. The 3 power rods on the blade arm also cast somewhat unreliably, as long as 2 complete lengths of red cast per arm im regarding it as a success. The rivets and serrations also come out slightly rounded off. The model
can be constructed using just super glue, but pinning or green stuff reinforcement makes it far more robust, as does mounting it on a base.
BlackLegion mentioned that it looked too large in the test cast image, however, the model's height and length can vary significantly depending on how the legs are positioned, as shown below.