| Tactical Command http://www.tacticalwargames.net/taccmd/ |
|
| Shapeways 3d printing http://www.tacticalwargames.net/taccmd/viewtopic.php?f=57&t=25739 |
Page 1 of 1 |
| Author: | Epaminondas [ Mon Aug 12, 2013 2:32 pm ] |
| Post subject: | Shapeways 3d printing |
Nice pile of BFG HH era ships and ork planes on my desk; before cleaning, should I wash them or just prime them. |
|
| Author: | jimmyzimms [ Mon Aug 12, 2013 2:53 pm ] |
| Post subject: | Re: Shapeways 3d printing |
What material did you print with? |
|
| Author: | Epaminondas [ Tue Aug 13, 2013 1:24 am ] |
| Post subject: | Re: Shapeways 3d printing |
Ultra fine detail |
|
| Author: | jimmyzimms [ Tue Aug 13, 2013 1:32 am ] |
| Post subject: | Re: Shapeways 3d printing |
I've gone straight to primer with FUD. Shouldn't hurt to wash them however. Just good practice. |
|
| Author: | Todderman [ Wed Aug 14, 2013 7:40 pm ] |
| Post subject: | Re: Shapeways 3d printing |
Yow. Mine are always covered in oily goo upon arrival. I give 'em a hot wash and detergent soak. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|