I had previously used a CR10-S4 but after a problem with the auto home and z-axis position, which I oculd not correct, I purchased a newer CS10-S% with part of my tax refund.
Since then, I have tightened the Y axis belt to stop a small slipping noise, levelled the bed, and it works fine.
Being PLA, it is always a little difficult to determine which little bits that looke like space fillers are not actual needed parts.
Even so, I think I did well in the trimming and deflashinhing of the extraneous bits.
I have printed 3 BFG Space Marine Strike Cruisers, one a carrier, one a lance strike cruiser, andother a heavy cannon srike cruiser.
I also printed 2 Bastons Epic scale, and 3 Khorne Doom Blaster Daemon Engines.
I have a multi-part BFG Luna Class Cruiser on the printer now which once deflashed should be posted up with a few more I intend to print during the next week.