Alright then as of now The polls show 3 of you would like to see more of this! and one of you just likes to click useless buttons ! ;P so lets do this!First off I cut the legs off of the sentinels ( this is easier if you have not glued them to begin with)
next I severed the battle cannon at the breach where it changes sizes , (keep all parts you cut off you'll-
need some of them later). then I use a hobby file to flatten the top of the turret , and bring the sides in more
and make them more parallel. I use a small pin vice to to drill out the breach to make the barrel.
also cut the Ork off of the looted gun, cut down on both sides of the gun to remove the Ork
( as seen in photo DC1 the cut flat along the underside of the gun then file off exes, then
mount the two guns side by side, see photo DC2.
Next we can cut the Chaos dreadnought in half see"photo DC2" for the cut, take note on the legs
off to the side where I cut it. next I cut the left gun off, leaving just half of the mounting arm.
for later, save the gun for another time. next up cut the head off of the Chaos dreadnought
right about the bottom of the third bump down its back( see photo DC3) then you will need to file the bottom of what is left of the dreadnought to fit on top of the Ork turret. when that's ready you can glue it to
the turret, then glue the gun you made ti the arm that use to have the Chaos dreadnought auto-cannon.
ok the rest will have to wait till tomorrow.
To be continued . . .